Re: Netflow not working on cisco site-to-site vpn router
Well, it depends on how it is configured, which router, and what IOS version Did you use the same template?
View ArticleRe: Netflow not working on cisco site-to-site vpn router
I seem to be getting flows after readding your template of commands so thank you once again, but the last router will let me enter all commands but " ip flow monitor MONITOR-1 input " on the external...
View ArticleRe: Netflow not working on cisco site-to-site vpn router
Is it working on the other interfaces, just not the external? Or is it not working on any interface?
View ArticleRe: Netflow not working on cisco site-to-site vpn router
i can add the command to vlan 1 but not the external, however i cant see any flows on the server
View ArticleRe: Netflow not working on cisco site-to-site vpn router
See my original response:"output-features" - requires 12.4(20). Is required to send Netflow packets over the VPN tunnel"export-protocol" - requires 12.4(22). Specifies what version of Netflow...
View ArticleRe: Netflow not working on cisco site-to-site vpn router
ok i will arrange that thanks for your help
View ArticleRe: Netflow not working on cisco site-to-site vpn router
this is what works for me in global config do this and be sure to change the port to the one you use, i use 9996 ip flow-cache timeout inactive 10ip flow-cache timeout active 1ip flow-export source...
View ArticleRe: Netflow not working on cisco site-to-site vpn router
Does this work over an IPSEC VPN? I have attempted this setup (traditional Netflow), but was never able to get this to send flows over my VPN.
View ArticleRe: Netflow not working on cisco site-to-site vpn router
i suggest that you run wire shark on both ends of the VPN.then compare what is sent out vs what is received. you have have some traffic being blocked
View ArticleRe: Netflow not working on cisco site-to-site vpn router
So you are using a Site-to-Site IPSEC VPN with this config?
View Article